Port Forwarding In UT300R2U ADSL MODEM

Hey guys..Hope you doing good!!Just yesterday somebody had requested me to write a tutorial on how to port forward in UT300R2U modem.In this modem port forwarding is a bit different.There is no VIRTUAL SERVER option.So you cannot forward ports like that.Instead there is something called NAT-DMZ . In NAT-DMZ all you do is enter the ip address of the computer where the port has to be opened and your done.Its that simple.I'll give you step by step instructions on how to do it.So here goes:

Step 1:Login to your router's menu by going to http://192.168.1.1 and enter admin as username and password

Step 2:You will see a page similar to this

Step 3:Now Go to Advanced Setup->NAT->DMZ-HOST ,you will find a page like this.

Step 4:This is where you will need to enter your computer's ip address
Step 5:To find out your ip address
In Windows go to the command prompt(Start->Run and type cmd) then type ipconfig and you should find your ip address mentioned there .It normally is under LOCAL AREA CONNECTION. it should be of the form 192.168.1.x .Sometimes 192.168.1.2 or 192.168.1.100 depends..
In Linux go to the Terminal(Application->Accessories->Terminal) and type ifconfig and you should find your ip address there.Here by default it normally will be under eth0. and in the same form as mentioned above..
Step 6:Then enter your ip address and click on SAVE/APPLY and reboot your modem.
Step 7:Thats it port forwarding is done in your modem.

Note:All ports will be forwarded to your computer in this case.Typically it would be your windows firewall which will be blocking them.So open ports in the windows firewall accordingly.CLICK HERE if you want to know how to open ports in windows firewall.